Home    |    About Us    |   FAQ's   |   Contact Us

  

 
 

Equipment Brands We Sell

Although we can service and repair all makes and models of HVAC equipment, we sell the following brands for new installations:


Air Specialist, Inc.

P.O. Box 1938

Pearland, Texas 77588

Phone: 713-733-9241

Fax: 713-733-9412

Email: service@airspecialist.com

Air Conditioning & Heating

We provide you with a great selection of dependable, time-tested brand name products that will give you the greatest flexibility when choosing a HVAC system that fits your budget, comfort level and safety. 

 

What makes Air Specialist the best choice as your service and installation advisor is the quality of our installation.

 

Value of our installation

The North Carolina Alternative Energy Corporation, a non-profit organization examined air manufacturers' efficiencies versus actual efficiencies that resulted after "professional" installation.  They found that 90% of the units tested exhibited some sort of energy-wasting, comfort-robbing problem!

 

Air Specialist will put you in the top 10%!

 

Other significant HVAC industry comfort and energy related surveys reveal:

 

Duct Leakage (93%)

  • Poor indoor air quality

  • Health and safety concerns

  • Drafts and uneven temperature

  • May DOUBLE your AC energy bill

Over sizing (47%)

  • Does not run enough to get moisture out

  • Air in sunlit rooms and shaded rooms does not mix

  • Equipment is typically noisier

  • Shorter equipment life

Incorrect Refrigerant Charge (54%)

  • Increased failure rate

  • Reduced moisture removal

  • Uneven temperature

  • Could add up to 17% to operating cost

Incorrect Air Flow (70%)

  • Uneven temperature

  • Poor moisture control

  • Noisy grilles and registers

  • Could add up to 10% to operating cost

FOR FASTEST SERVICE, CALL US

(713) 733-9241

HVAC Installation Quality Audit & Customer Approval

Here is a list of the detailed steps we perform to ensure that your new system is operating at peak efficiency and putting you in the TOP 10%

 

Furnace Air/Handler set - blowers speed set for proper cfm
Filter rack installed
Evaporator coil installed and leveled
Emergency drain pan and safety switch installed and tested
Gas piping completed and leak tested
Furnace venting complete with proper supports, clearance and rise
Combustion air intake completed
All pilot lights lit (furnaces and water heaters check out)
Condenser set with vibration pads in place
Condenser level
Refrigerant piping completed and leak tested
Condensate drain installed and tested
Condensate pump installed, safety switch wired and tested
Thermostat installed level, heat anticipator set, and checked out
Air cleaner installed
Electronic air cleaner operation (include air flow switch) checked
Ducting complete
Supply air dampers installed
Registers installed and level
Insulation complete
Low voltage complete
Line voltage completed
Furnace started up and checked out (dip switches set - variable speed)
Air conditioner or heat pump started up and checked for proper refrigerant charge
Electric heat started up and checked out
All work areas clean and trash removed
Homeowner given all homeowner's manuals
Homeowner instructed on how to operate humidstat, thermostat and clean or change filters
  

Copyright © 2010 Air Specialist, Inc.  All rights reserved.

TACLA 024284E / TACLA 024285E

Regulated by the Texas Department of Licensing and Regulation